3d drawing easy shapes: tutorials and tips and tricks

3d drawing easy shapes: tutorials and tips and tricks

Drawing 3-D 3D easy forms: 5 expert tutorials and tips.

3-D forms are the base for this when you just want to learn how to draw. When you know how to imply multidimensional form, you can apply your knowledge to all kinds of subjects.

Make your work pop-up off the 3d drawing tutorials step-by-step 3-D shapes!


You don’t need any special equipment to learn this skill. But wear crayons, colored pencils, crayons and whatever you want, don’t hesitate. I use pencil and paper

Here are tutorials with a few helpful tricks for five different 3D forms. The steps to build the overall shape are divided into simple steps.

1. How to draw 3D triangles 1.

Two forms of triangles exist prisms (left) and pyramids. It’s there (right).

Phase 1: Step 1:

Start with a simple, flat triangle and a small horizon point on the shape side when a simple prism is formed by 3d drawing. It doesn’t matter which side you pick. The length and angle of the prism depend on where the horizon is centered.

Draw three lines, as shown on the right top, for the building of a pyramid. There should be a straight line in the middle. Draw from the top of the straight line two angled lines of the same length.

Step 2:

Give your prism a three-dimensional look by drawing easy forms, two lines: one at the top and one at the base angle of the triangle closer to the horizon. Draw lines slightly over the horizon.

Three lines connected to the bottom of the pyramid finish the 3d drawing easy forms. Draw a pointing horizontal line and use angled lines to link each angled line to the centerline in order to connect two angled lines.

2. Simple 3d cubes drawing forms

Cubes can be drawn in several ways, and here I’ve created two.

Phase 1:

To start the first cube, draw 2 squares of the same size. But what about you? But what is your responsibility? You could overlap.


Draw the second cube much as you did the pyramid. Three vertical lines of the same size are created this time. This time. – This time. The two external lines must start and end simultaneously, with the medium line on the page varying somewhat.

Phase 2:

All the corners are now connected. Use a right edge to draw the corner lines to align the sides of the first cube. The first square lower right angle is then placed on the second square underneath the right angle. This will be repeated in all four corners.

Repeat with bottom points for the tops of the second cube with angled lines. For the second cube. For the second cube. Draw a point right above the centerline—the gap between the center line and the centerline should be about the middle line. Hook up with angled lines on the tops of both external lines.

Ali raza


leave your comment